Datasheet

8
1. Voltage Scale 2.Waveform 3. Amplitude 4. Time Scale
5. Output Information 6. Working Parameters 7. Operation Menu
4.2 Number Entry
4.2.1 Use the keypad to enter numbers and softkey to select unit.
Please use 【<】key to cancel mistake enter before select unit key. Don’t forget to select
unit key after finishing entering number. Only this, the enter data can come into effect.
Press 〖Cancel〗softkey in unit menu to cancel the enter data that has come into effect.
4.2.2 Use the knob and arrow keys to modify the displayed number.
Use the arrow keys 【<】 【>】to move the cursor left or right. While, rotate the knob to
change digits. (clockwise to increase and the inverse to decrease). It’s not necessary for
user to select unit if entering number by this way.
Users can enter numbers by one of three mentioned methods based on different
applications.
4.3 Basic Operation
4.3.1 To select the output channel
Press 【CHA/CHB】key to open desired channel configuration screen. Note that fonts of
channel name, mode and waveform were indicated by different color (yellow for CHA
and blue for CHB). Use softkey together with knob or numeric keypad to set the
waveform and parameters of desired channel. Enable or disable the output signal of
desired channel by pressing 【Output】key.
4.3.2 To select a waveform
Press 【Waveform】key to see the first page of the option list Sine, Square, Ramp, Pulse,
Arbitrary and Noise. If select Arbitrary option, there are some operations for arbitrary
waveform. Select one desired waveform to see the waveform diagram under Continuous
mode.