Datasheet

46
(4) Block Copy: Press〖BMode〗and select “Copy” mode.
Always use the current selected wave.
Press〖PosSel〗key to set copy position to be 650, that the white cursor cross is the
position ready for insert, where is front the Sinc.
Press 〖Execute〗key to copy the block wave to specified position and cover the part
of Sinc wave behind the point.
(5) Operation Sequence: The sequence for inserting and copying is always from X1 to
X2. If coordinate X2 larger than X1, the block insert or copy direction will be from left
to right. If coordinate X2 less than X1, the block insert or copy direction will be from
right to left, which means the block wave is reverse image inserted.
Now change the X1 and X2 to each other, to make X2 less than X1.
Press 〖X1〗key to set start coordinate to be 300, that the green cursor cross will be
the start point.
Press 〖X2〗key to set stop coordinate to be 150, that the red cursor cross will be the
stop point. The selected block wave is the last half part of Tangent.
Press 〖Execute〗key, you will see that the selected block wave to be copied as
reversed image to specified position.