Datasheet

44
The example shows how to do linear modification to a sine wave with 100 points.
(1) Insert a sine wave with 100 points as the method introduced in chapter 5.15.2.
(2) Press 〖Line Edit〗key to enter into the editing window. X1 and Y1 indicate the start
coordinate of a line in green. X2 and Y2 indicate the stop coordinate of a line in red.
(3) Press 〖X1〗key and set the X1 to be 10. Press 〖Y1〗key and set Y1 to be 1Vdc,
the green crossing is the start point of the line.
(4) Press 〖X2〗key and set the X2 to be 10. Press 〖Y2〗key and set Y2 to be 0mVdc,
the red crossing is the stop point of the line.
(5) Press 〖Execute〗key and generator will link up the start and stop point and send the
new waveform to output.
5.15.6 Block Edit
By Block Editing, user can insert, copy or delete the block wave to existing waveform and
create a very complicated arbitrary waveform.
The example shows how to do the Block Edit to a arbitrary wave consit
(1) Insert below three different waveforms as the method introduced in chapter 5.15.2.
Sinc Wave, amplitude 1.000Vpp, Offset 310mVdc, phase 0.0°, total points 150.
Sine Wave, amplitude 500mVpp, Offset 0mVdc, phase 180°, total points 200.