Datasheet

Once X and Y cursor are both on, user can press 〖Select Point〗and turn the knob

to see the two cursor crossing moving along with the trace of sine, also the X and Y

axis value of each point. When cursor move to where X-axis is 0, Y-axis is 1.000V,

that is also the setting of step 4 and 5 above.

In picture, the value of X and Y axis are auto adjusted by varying of setting range.

The feature is applicable for other editing modes.

(5) Move the X-axis to 50 and repeat pressing〖Point Edit〗5 times, you will observe that

5 points with same voltage are added to where 50 points locates and total points are

plus 5:

(6) Move the Y-axis to 26 and repeat pressing 〖Point Delete〗10 times, you will observe

that 10 points are deleted at where 26 points locate and total point decreased 10.

5.15.4 Line Edit

For Line Edit, user only need to set two points and generator will follow the linear

regulation and auto set all the points between the two points, then connect which by a

line. So compared to Point Edit, Line Edit could be quicker at creating the waveform by

setting lots of points one time, applicable for linear modification to existing waveform or

create a line waveform.