Datasheet

34
Press〖Start Number〗softkey to set start number. The start number should be less than
stop number, if not, the generator will set start number less 1 than stop number.
Press〖Stop Number〗softkey to set stop number. The stop number should be larger than
start number, if not, the generator will set stop number more 1 than start number.
5.12.5 Dwell Time
Press〖Dwell Time〗 softkey. Then use the knob or numeric keypad to enter the desired
dwell time. The dwell time specifies the number of seconds to remain at each frequency
point.
5.12.6 Hold Time
After enabling sweeps, press 〖Hold Time〗 softkey. Then use the knob or numeric
keypad to enter the desired hold time. The hold time specifies the number of seconds to
remain at the stop number.
5.12.7 Trigger Source
Press〖Trig Imm/Ext〗softkey. When Immediate selected, the waveform generator takes
internal source and trigger sweep repeat running. When manual mode selected, the
waveform generator outputs one sweep each time you press 〖Manual Trig〗 softkey.
When External selected, generator takes external source, the detail description refer to
chapter 5.14.
5.13 Burst Output
Press 【Burst】 key to enter into the sweep mode. The burst waveform sketch and burst
menu will be both displayed.
5.13.1 Set Burst Signal
First set the shape of burst signal. Normally sine is selected for burst signal, the other
buit-in waveform are also could be selected except of some waveforms. Press 〖Burst
Signal〗softkey to set frequency, amplitude and offset of burst signal.
5.13.2 Burst Mode
You can use burst in two modes by pressing 〖Mode Trig/Gat〗softkey to select.
(1) If ‘Triggered’ is selected, the waveform generator outputs a waveform with a
specified number of cycles (burst count) each time a trigger is received. After the
specified number of cycles have been output, the waveform generator stops and
waits for the next trigger.