Datasheet

You also can generate signal burst (still with 5 cycles) by selecting Manual Trig under

pressing 〖Source Int/Ext〗softkey. Then each time you press 〖Manual Trig〗softkey, one

five-cycle burst will be output. Press number depends on the desired burst number.

4.3.12 Frequency Coupling

If you want to couple frequencies between the two channels,

1. Press 【Dual Channel】key. The dual channel menu is shown in the current screen.

2. Press the 〖Freq Cpl〗softkey to turn frequency coupling on. Then press 〖More〗

softkey to configure frequency coupling.

3. Press 【 Continuous】 key to configure CHA frequency, just because channel

frequencies can be linked with a constant ratio or difference between them, CHB

frequency will be changing as CHA changes.

4.3.13 Frequency Counter

If you want to measure a frequency of external signal,

1. Press 【Counter】key to enter into Counter mode and display the counter menu and

count results.

2. Input measured signal through ‘Counter’ connector at rear panel.

3. Press 〖Meas Type〗softkey, the generator begin to measure then display the

measured frequency value.

4. For Square input, press 〖Duty cyc〗softkey to enable the duty cycle measurement

and display the duty cycle.