Datasheet

Press 【Sweep】key and then verify that the Sweep is selected in default.

2. Select sweep time

Press the 〖Sweep Time〗softkey then set the value to 5s using the numeric keypad or

the knob and arrow keys.

3. Select sweep mode

Press the 〖Mode Line/Log〗softkey and then verify that the logarithmic sweep mode is

currently selected on the first softkey.

4.3.11 To output a Burst waveform

If you want to output a five-cycle wave with a 10ms burst period, continuous or manual

signal trigger.

1. Press 【Burst】key then burst menu is shown in the screen of the current channel.

2. Press 【Burst Mode】and select the ‘Triggered’.

3. Press 〖Burst Period〗softkey then set the value to 10ms using the numeric keypad

or the knob and arrow keys.

4. Press 〖N Cycle〗 softkey then set the value to 5 using the numeric keypad or the

knob. Press the 〖Ok〗 softkey to finish data entry if you are using the numeric

keypad.

At this point, the waveform generator outputs a continuous five-cycle burst at 10 ms

intervals.