Datasheet

10
4.3.6 To set offset
For example, specify an offset to -25mVdc.
Press 〖Offset〗softkey and then set the offset to -25mVdc using the numeric keypad or
the knob and arrow keys 【<】【>】. If you use the keypad, press 〖mVdc〗 softkey to
finish entering the value.
4.3.7 To output an AM waveform
A modulated waveform consists of a carrier and a modulation waveform. In AM, for
example, you want to output an AM waveform with 80% modulation depth, the carrier will
be 10kHz and the modulation waveform will be a 10Hz Ramp wave.
1. Select AM
Press 【Modulate】key and then select 〖AM〗softkey by pressing the〖Mod Type〗softkey.
2. To set Carrier frequency
Press〖Carrier〗to enter into the parameter setting. Then press〖Freq〗softkey, enter 10
kHz with the numeric keypad or the knob and arrow keys. Press 〖kHz〗softkey to finish
entering the number.
3. To set the modulation depth