User Manual

Note:
1. When the input is not connected, i. e. at open circuit, the figure "OL" will
be displayed for the overrange condition.
2. There is 1mA Current flow through the device under test.
3. The meter displays the forward voltage drop in millivolts, and overload
when the diode is reversed.
6.9. Audible Continuity Test
1. Connect the black test lead to the COM jack and the red test lead to the
V/- jack.
2. Set the Function switch to " Ω / /
.
))) " range and connect the test
leads across the resistance under measurement.
3. Select continuity-function by pressing “MODE”-button.
4. Buzzer sounds if the resistance between two prods is less than approx.
50.
Note:
1. When the input is not connected, i. e. at open circuit, the Figure "OL" will
be displayed for the overrange indication.
2. The circuit to be tested must be in power off status during the continuity
check.
6.10. Measuring Sound Level
1. Set the function to „dBC“ Position.
2. Face the microphone to sound source in a horizontal position.
-47-