User Manual

6.4. DC Current Measurement
1. Connect the black test lead to the COM jack and the red test lead to the
µA/mA- jack for a max. of 400mA. For a maximum of 10A, move the red
test lead to the 10A jack.
2. Set the Function switch to the µA/mA or 10A range to be used and
connect the test leads in series with the load under measurement
3. Select DC by pressing the “MODE” button.
Note:
1. If the current range is not known beforehand, set the FUNCTION switch
to the highest range and work down.
2. When only the figure "OL" is displayed overrange is being indicated and
the FUNCTION switch must be set at higher range.
3. Caution: The maximum input current is 400mA, or 10A depending upon
the jack used. Excessive current will blow the fuse which must be
replaced.
6.5. AC Current measurement
1. Connect the black test lead to the COM jack and the red test lead to the
µA/mA jack for a max. of 400mA. For a maximum of 10A, move the red
test lead to the 10 A jack.
2. Set the function switch to the µA/mA or 10A range to be used and
connect the test leads in series with the load under measurement.
3. Select DC by pressing “MODE”-button.
-44-