User Manual

Remote Test
1. Plug one end of the tested cable to the transmitting RJ-45
jack on the master unit marked with a “symbol” and plug the
other end into the remote terminator. If the tested cable is
installed in a patch panel or wall plate, you may use the
included patch cable to solve the connector gender problem.
2. Now, set the Auto/Manual switch to Auto mode for one-
person testing.
3. Read the test results from the LED display on remote
terminator.
Note: The LED display on the remote unit will scan in sequence
corresponding to the transmitting end of the master unit.
Caution:
1. Operating the tester in live circuits may damage the tester
2. Leaving the battery in the tester for long periods of time
without use could drain power from the battery
-43-