User Manual

2. Press the MODE-button to indicate Ω on the display.

3. Touch the test probe tips across the circuit or part under

test. It is best to disconnect one side of the part under test

so the rest of the circuit will not interfere with the resistance

reading.

4. Read the resistance in the display.

Note:

1. If the resistance value being measured exceeds the

maximum voltage of the range selected, an over-range

indication will be displayed ("OL"). Select a

higher range. For resistance approx. 1 M and

above, the meter may take a few seconds to stabilize.

This is normal for high resistance readings.

2. When the input is not connected, i. e. at open circuit, the

figure "OL" will be displayed for the overrange condition.

3. When checking in-circuit resistance, be sure the circuit

under test has all power removed and that all capacitors

are fully discharged.

5.7. Continuity Check

WARNING! To avoid electric shock, never measure

continuity on circuits or wires that have voltage on them.

1. Set the function switch to the Ω / /

))) position.

2. Press the MODE-button to indicate

))) on the display.

3. Touch the test probe tips to the circuit or wire you wish to

check.

-37-