User Manual

3. Use extreme caution to avoid contact with high tension
circuits when measuring high voltage.
5.3. AC Voltage Measurement
1. Set the function switch to the V position.
2. Press the MODE-button to indicate “AC” on the display.
3. Touch the black test probe tip to the negative side of the
circuit. Touch the red test probe tip to the positive side of the
circuit.
4. Read the voltage in the display.
Note:
1. Caution: Do not apply more than 600 V
rms
to the input.
Indication is possible at higher voltages but there is danger
of damaging the internal circuitry.
2. Use extreme caution to avoid contact with high tension
circuits when measuring high voltage.
5.4. DC Current Measurement
1. Set the function switch to the µA/mA position.
2. Press the MODE-button to indicate “DC” on the display.
3. Remove power from the circuit under test, then open up the
circuit at the point where you wish to measure current.
4. Connect the test leads in series with the load under
measurement.
5. Apply power to the circuit.
-35-