User Manual

1. Introduction
2 in 1 LAN Tester & Multimeter is a innovative tester that allows
the user easy to measure DC/AC Voltage/Current, Resistance,
Continuity, diode and verify the cable continuity, open short,
cross connect. The included remote terminator allows the user to
test installed cable either at a wall jack or a patch panel adding
up to value and convenience. Proper use and care of this meter
will provide years of reliable service.
2. Features
* 2 in 1-LAN Tester & Multimeter
* Measures DC/AC Voltage, DC/AC Current, Resistance,
Continuity, diode and LAN tester
* 3 ½ digit (2000 count) LCD display for multimeter functions
* LED Displays the actual pin configuration of 10BASE-T and
10BASE-2 Thin Ethernet, RJ45/RJ11 modular, 258A, tia-
568a/568b and Token Ring cables
* Double Molded housing
* CAT III 600 V
* Provides easy to read continuity and fault status display
* Checks for continuity, open wire, ground wire, shorted pair
and crossed pair faults
* Allows for remote testing of installed cables from wall jack or
patch panel
* auto or manual scanning for LAN tester
* Autoranging with auto power off for multimeter functions
-27-