User Manual

5.11. Capacitance measurements
Warning:
To avoid electric shock, disconnect power to the unit under test and
discharge all capacitors before taking any capacitance
measurements. Remove the batteries and unplug the line cords.
1. Set the function switch to the "CAP" ┤├ position.
2. Insert the black test lead banana jack into the negative COM
jack and the red test lead banana plug into the positive ┤├
jack.
3. Touch the test leads to the capacitor to be tested. The display
will indicate the proper decimal point, value and symbol.
5.12. Temperature measurements
Warning:
To avoid electric shock, disconnect both test probes from any
source of voltage before making a temperature measurement.
Insert the adapter in the input socket for temperature
measurements.
Insert the K-type thermocouple into the temperature socket, making
sure to observe the correct polarity. Touch the temperature probe
head to the part whose temperature you wish to measure. Keep the
probe touching the part under test until the reading stabilize (about
30 seconds). Read the temperature in the display. The digital
reading will indicate the proper decimal point and value.
Warning:
To avoid electric shock, be sure the thermocouple has been
removed before changing to any other measurement function.
-57-