User Manual

4.3. AC/DC Voltage Measurement
1. Set the slide switch at V ~ position.
2. Connect the black test lead to the COM terminal and the red
test lead to the “V-Ω” terminal. You can now place the probes to
the conductors to make the measurement.
3. Pushing the AC/DC switch to select AC or DC mode.
4.4. Resistance Measurement
1. Set the slide switch at “Ω/
°
)))" position.
2. Connect the black test lead to the COM terminal and the red
test lead to the V-Ω terminal.
3. Verify that the power to the circuit under test is off. Connect test
leads to the circuit to make the measurement.
4. Pushing the Ω/
°
))) switch to select resistance mode or continuity
mode.
5. At continuity mode, built-in buzzer sounds if the resistance of
the circuit under test is less than 50 Ω.
5. Maintenance
WARNING!
To avoid electrical shock remove test lead before opening the
cover.
Repairs or servicing not covered in this manual should only be
performed by qualified personal.
-30-