User Manual

5. H/MAX Switch

This switch has two modes, one is data hold the other is

maximum hold. Sliding the function switch to power on, this

switch will work in data hold mode. Pressing the H/MAX switch

then slide the function switch from power off to power on, this

switch will work in maximum hold mode.

Data Hold mode

This mode is used to hold measured value for all functions,

push this switch then HOLD annunciator is displayed.

Conversions are made but the display is not updated.

Maximum Hold mode

This mode is used to hold the maximum measured value for all

functions except continuity mode. Press this switch the “MAX”

annunciator turns on then enters the maximum hold mode.

Press this switch again to restart recording. Press this switch

more than 2 seconds to exit the maximum hold mode.

6 Zero Switch

This switch is used to zero the reading on display. It work in DC

and AC current function only. In zero mode, the reading maybe

exceed ± 4000 counts.

7. Ω/AC/DC Selection switch

Push this switch alternately to measure AC voltage or DC

voltage in the V ~ function or to measure AC current or DC

current in the A ~ function. or to measure resistor or continuity

in Ω/function. Auto power disable mode - press this switch until

slide the function switch power on for 1 second it will cause the

auto power off function disable.

8. Trigger

Press the lever to open the transformer jaws. When the

pressure on the lever is released, the jaws will close again.

9. Hand Guard

Designed to protect user for safety.

-27-