User Manual

8. Measuring consideration
Reflective Mark
• Cut and peel adhesive tape provided into approx. 12 mm
(0,5”) squares and apply one square to each rotation shaft.
• The non-reflective area must always be greater than the
Reflective area.
• If the shaft is normally reflective, it must be covered with black
Type or black paint before attaching reflective tape.
• Shaft surface must be clean and smooth before applying
Reflective tape.
9. Very low RPM Measurement
During the measurement of very low RPM-measurements we
recommend to use several reflective tapes for the measurement
object to ensure high resolution and fast sampling time. After the
measurement you have to divide the value by the number of tapes
strips u used for the measurement.
-19-