User Manual

8.1. Installing the battery
Your meter requires a 9V battery for power. The battery symbol appears
when the battery voltage drops to certain limits. For correct operation,
replace the battery as soon as possible. Continued use with a low
battery will lead to errors in readings.
WARNING!
To avoid electric shock, disconnect all leads from any equipment before
you remove or install the battery.
Follow these steps to install the battery.
1. Turn off the power and disconnect all test leads.
2. Remove the screw to open the battery compartment.
3. Place the battery inside and snap it on to place.
WARNING!
Do not discard the provided battery insulation capsule. If you do not use
this insulation capsule properly, it might cause damage or injury.
WARNING!
Do not operate the meter until you replace the battery and close the
battery compartment cover.
-46-