User Manual

6. Steps before using
6.1. Connection of test leads
CAUTION!
Note on using the supplied safety test leads according the IEC / EN
61010-031:2008:
Measurements in the field of overvoltage category CAT I or CAT II can
be performed with test leads without sleeves with a maximum of up to
18mm long, touchable metallic probe, whereas for measurements in the
field of overvoltage category CAT III or CAT IV test leads with put on
sleeves, printed with CAT III and CAT IV must be used, and therefore
the touchable and conductive part of the probes have only max. 4mm of
length.
Caution!
The max. input voltage for this instrument is 600V DC or AC and to be
on the safe side, these values mustn´t be passed. Higher voltage-
differences may cause personal injury or damage of the unit.
6.2. Angle position of the unit
This multimeter is provided with a stand at it´s backside for having and
angle-position.
-38-