User Manual

C.C. Indicator check
Rear control indicator check
Return to C.V.
Start to check
Over voltage protection check
Over load protection check
Over temperature protection check
Fan check
Output off (remote control mode)
(Remote Control Modus)
8. Using the control knobs
8.1. The rotary encoder control knobs have fine and coarse tuning with clicking movement.
Push the knobs to toggle between coarse and fine tuning, notice the subtle changes in
brightness of related LED.
Adjust the knobs to your desired values by trying coarse and fine tuning. The display will
resume its normal brightness after few seconds to confirm your adjustment.
8.2. Connect the equipment to the power supply. Red (+) is connected to the positive polarity
input of the equipment and Black (-) is connected to the negative polarity input of the
equipment.
8.3. Switch on the power supply first and the panel meter & green CV Indicator should light up
again.
8.4. Switch on the equipment and the panel meter & green CV Indicator should still remain in
green.
8.5. You can now operate the equipment. When an operation is finished, switch off the
equipment first and then switch off the power supply.
-38-