User Manual

6.5.2 To reset the unit back to factory setting
1. Turn OFF the power supply
2. Push and hold both front panel voltage and current control knobs at the same time
3. Turn ON the power supply again
4. Release front panel voltage and current control knobs
6.6 Remote Control Mode
To control the output voltage and current by remote control connector (10)
7. Using the power supply
7.1. This series has 4 models. Make sure you have used the correct one. They have different
output voltage range and current as following:
Model Number
Output Voltage Range
Total Rated Current
PeakTech
®
1565
1 – 16 V
0-40 A
PeakTech
®
1570 0-60 A
PeakTech
®
1575
1 – 32 V
0-20 A
PeakTech
®
1580 0-30 A
7.2. Make sure the Mode Switch (8) is at Normal Position. (9) P 1570
7.3. The power supply will perform a series of self checks when it is switched on. The LED and
other indicators on the front panel will be on by turn. When the cooling fan is being
checked, a high speed wind noise can be heard.
After the self checks, the CV, V and A LED indicators are lit up displaying voltage and 0.0
current. To find out about the set CC current level, just turn the current control knob one
click in either direction. The current display returns to 0.0 after a few seconds.
Below table to show the self test sequence
Self test display and Sequence Test contents
To show software version
Segment check
C.V. Indicator check
-
37
-