Datasheet

5.Use the Arbitrary Function Generator (Optional to specific models)

Push button to switch between CH1 menu, CH2 menu, and Channel Copy menu.

 To Turn On/Off Output of Channels

Push or to turn on/off output of the corresponding channel. The indicator

will be lighted when the corresponding channel is tuned on.

 Channel Copy menu

Push button to switch to Channel Copy menu.

Copy Channel

Select CH2 To CH1 in the bottom menu to copy parameters of CH2 to CH1.

Select CH1 To CH2 in the bottom menu to copy parameters of CH1 to CH2.

Frequency Lock

Select Freq Lock in the bottom menu as On, the frequency of the two channels can be

adjusted synchronously.

Amplitude Lock

Select Ampl Lock in the bottom menu as On, the amplitude of the two channels can be

adjusted synchronously.

Align Phase

Select Align Phase in the bottom menu to align the initial phase of two channel signals.

To Set Signals

(1) Push (single-channel) or (dual-channel) button to show the bottom

menu of generator.

(2) Select the desired waveform in the bottom menu, the corresponding menu is displayed

on the right.

(3) The parameters can be set in the right menu.

To Output Sine Signals

The parameters of Sine waveform in the right menu are: Frequency/Period, Start Phase,

Amplitude/High Level, Offset/Low Level.

To Set the Frequency

Select Frequency in the right menu (if Frequency is not displayed, select Period and

push it again to switch to Frequency). Set the parameter in the right menu, see below.