Datasheet

57
8. Technical Specifications
Unless otherwise specified, the technical specifications applied are for the oscilloscope only,
and Probes attenuation set as 10X. Only if the oscilloscope fulfills the following two conditions
at first, these specification standards can be reached.
 This instrument should run for at least 30 minutes continuously under the specified
operating temperature.
 If change of the operating temperature is up to or exceeds 5℃, do a "Self-calibration"
procedure (see "How to Implement Self-calibration" on P14).
All specification standards can be fulfilled, except one(s) marked with the word "Typical".
Performance Characteristics
Instruction
Bandwidth
P 1335
20 MHz
P 1336
50 MHz
P 1337
100 MHz
Channel
2 channels
Acquisition
Mode
Normal, Peak detect, Averaging
Sample rate
(real time)
P 1335
100 MS/s
P 1336
500 MS/s
P 1337
1 GS/s
Input
Input coupling
DC, AC , Ground
Input impedance
1 MΩ±2%, in parallel with 20 pF±5 pF
Input coupling
1X，10X，100X，1000X
Max. input voltage
400V (DC+AC, PK - PK)
Channel –channel
isolation
50Hz: 100 : 1
10MHz: 40 : 1
Time delay between
channel(typical)
150ps
Bandwidth limit
P 1335
P 1336
Not support
P 1337
20 MHz, full bandwidth
Horizontal
System
Sampling rate range
P 1335
0.5 S/s～100 MS/s
P 1336
0.5 S/s～500 MS/s
P 1337
0.5 S/s～1 GS/s
Interpolation
(Sinx)/x
Max Record length
10K
Scanning speed (S/div)
P 1335
5 ns/div – 1000 s/div,
step by 1 – 2 - 5
P 1336
P 1337
2 ns/div – 1000 s/div,
step by 1 – 2 - 5
Sampling rate / relay time
accuracy
±100 ppm