Datasheet

48
5. Communication with PC
The oscilloscope supports communications with a PC through USB. You can use the Oscilloscope
communication software to store, analyze, display the data and remote control.
To learn about how to operate the software, you can push F1 in the software to open the help
document.
Here is how to connect with PC via USB port.
(1) Install the software: Install the Oscilloscope communication software on the supplied CD.
(2) Connection: Use a USB data cable to connect the USB Device port in the right panel of the
Oscilloscope to the USB port of a PC.
(3) Install the driver: Run the Oscilloscope communication software on PC, push F1 to open the
help document. Follow the steps of title "I. Device connection" in the document to install the
driver.
(4) Port setting of the software: Run the Oscilloscope software; click "Communications" in the
menu bar, choose "Ports-Settings", in the setting dialog, choose "Connect using" as "USB".
After connect successfully, the connection information in the bottom right corner of the
software will turn green.
Figure 5-1 Connect with PC through USB port