Datasheet

46
Trigger Type
Slope or Video
Trigger Source
CH1 or CH2
Trigger Coupling
DC
Trigger Slope
Current
Trigger Level
3/5 of the waveform
Trigger Mode
Auto
Display Format
YT
Force
Stop
Inverted
Off
Zoom Mode
Exit
Judge waveform type by Autoset
Five kinds of types: Sine, Square, video signal, DC level, Unknown signal.
Menu as follow:
Waveform
Menu
Sine
Multi-period, Single-period, FFT, Cancel Autoset
Square
Multi-period, Single-period, Rising Edge, Falling Edge,
Cancel Autoset
Video signal
Type (line, field), Odd, Even, Line NO., Cancel Autoset
DC level/Unknown signal
Cancel Autoset
Description for some icons:
Multi-period： To display multiple periods
Single-period： To display single period
FFT： Switch to FFT mode
Rising Edge： Display the rising edge of square waveform
Falling Edge： Display the falling edge of square waveform
Cancel Autoset：Go back to display the upper menu and waveform information
Note: The Autoset function requires that the frequency of signal should be no lower than 20Hz,
and the amplitude should be no less than 5mv. Otherwise, the Autoset function may be invalid.
 [Run/Stop] button
Enable or disable sampling on input signals.
Notice: When there is no sampling at STOP state, the vertical division and the horizontal time
base of the waveform still can be adjusted within a certain range, in other words, the signal can
be expanded in the horizontal or vertical direction.
When the horizontal time base is ≤50ms, the horizontal time base can be expanded for 4
divisions downwards.
 [Copy] button
This button is the shortcut for Save function in the Utility function menu. Pressing this button is
equal to the Save option in the Save menu. The waveform, configure or the display screen
could be saved according to the chosen type in the Save menu. For more details, please see "