Datasheet

43
Window
(Wave
zoom
mode)
Main
Extension
Measure in the main window.
Measure in the extension window.
Line
a
b
ab
Turn the M knob to move line a.
Turn the M knob to move line b.
Two cursors are linked. Turn the M knob to move the pair
of cursors.
Source
CH1
CH2
Display the channel to which the cursor measurement
will be applied.
Perform the following operation steps for the time and voltage cursor measurement of the
channel CH1:
1. Push Cursor to display the cursor menu.
2. In the right menu, select Source as CH1.
3. Press the first menu item in the right menu, select Time&Voltage for Type, two blue
dotted lines displayed along the horizontal direction of the screen, two blue dotted lines
displayed along the vertical direction of the screen. Cursor measure window at the left
bottom of the screen shows the cursor readout.
4. In the right menu, select Line Type as Time to make the vertical cursors active. If the
Line in the right menu is select as a, turn the M knob to move line a to the right or left. If b
is selected, turn the M knob to move line b.
5. In the right menu, select Line Type as Voltage to make the horizontal cursors active.
Select Line in the right menu as a or b, turn the M knob to move it.
6. Push the horizontal HOR button to enter wave zoom mode. Push Cursor to show the
right menu, select Window as Main or Extension to make the cursors shown in the main
window or zoom window.
Figure 0-9 Time&Voltage Cursor Measurement