Datasheet

39
RMS, Cursor RMS, Screen Duty, Phase, +PulseCount, -PulseCount, RiseEdgeCnt, FallEdgeCnt,
Area, and Cycle Area.
The "Automatic Measurements" menu is described as the following table:
Function Menu
Setting
Description
AddCH1
Meas Type
(left menu)
Press to show the left menu, turn the M knob to
select the measure type, press AddCH1 again to
add the selected measure type of CH1.
AddCH2
Meas Type
(left menu)
Press to show the left menu, turn the M knob to
select the measure type, press AddCH2 again to
add the selected measure type of CH2.
Show
OFF
CH1
CH2
Hide the window of measures
Show all the measures of CH1 on the screen
Show all the measures of CH2 on the screen
Remove
Meas Type
(left menu)
Press to show the left menu, turn the M knob to
select the type need to be deleted, press Remove
again to remove the selected measure type.
Remove All
Remove all the measures
Measure
Only if the waveform channel is in the ON state, the measurement can be performed. The
automatic measurement can not be performed in the following situation: 1) On the saved
waveform. 2) On the Dual Wfm Math waveform. 3) On the Video trigger mode.
On the Scan format, period and frequency can not be measured.
Measure the period, the frequency of the CH1, following the steps below:
1. Push the Measure button to show the right menu.
2. Select AddCH1 in the right menu.
3. In the left Type menu, turn the M knob to select Period.
4. In the right menu, select AddCH1. The period type is added.
5. In the left Type menu, turn the M knob to select Frequency.
6. In the right menu, select AddCH1. The frequency type is added.
The measured value will be displayed at the bottom left of the screen automatically (see Figure
0-6).