Datasheet

32
When the Type is selected as Configure, the menu is shown as the following table:
Function Menu
Setting
Description
Function
Save
Display the save function menu
Type
Configure
Choose the saving type as configure.
Configure
Setting1….
.
Setting8
The setting address
Save
Save the current oscilloscope configure to the
internal storage
Load
Recall the configure from the selected address
When the Type is selected as Image, the menu is shown as the following table:
Function Menu
Setting
Description
Function
Save
Display the save function menu
Type
Image
Choose the saving type as image.
Save
Save the current display screen. The file can be
only stored in a USB storage, so a USB storage
must be connected first. The file name is
editable. The file is stored in BMP format.
Save and Recall the Waveform
The oscilloscope can store 16 waveforms, which can be displayed with the current waveform at the
same time. The stored waveform called out can not be adjusted.
In order to save the waveform of CH1, CH2 and Math into the object Wave0, the operation steps
should be followed:
1. Turn on CH1, CH2 and Math channels.
2. Push the Utility button, select Function in the right menu, select Save in the left menu. In the
right menu, select Type as Wave.
3. Saving: In the right menu, select Source as All.
4. In the right menu, press Object. Select Wave0 as object address in the left menu.
5. In the right menu, press Next Page, and select Storage as Internal.
6. In the right menu, press Save to save the waveform.
7. Recalling: In the right menu, press Prev Page, and press Object, select Wave0 in the left
menu. In the right menu, select Object as ON, the waveform stored in the address will be
shown, the address number and relevant information will be displayed at the top left of the
screen.