Datasheet

30
The operations of all control knobs are as follows:
 The Vertical Scale and the Vertical Position knobs of Channel 1 are used to set the
horizontal scale and position.
 The Vertical Scale and the Vertical Position knobs of Channel 2 are used to set the vertical
scale and position continuously.
The following functions can not work in the XY Format:
 Reference or digital wave form
 Cursor
 Trigger control
 FFT
Operation steps:
1. Push the Acquire button to show the right menu.
2. Select XY Mode as ON or OFF in the right menu.
Counter
It is a 6-digit single-channel counter. The counter can only measure the frequency of the triggering
channel. The frequency range is from 2Hz to the full bandwidth. Only if the measured channel is in
Edge mode of Single trigger type, the counter can be enabled. The counter is displayed at the
bottom of the screen.
Operation steps:
1. Push Trigger Menu button, set the trigger type to Single, set the trigger mode to Edge, select
the signal source.
2. Push the Acquire button to show the right menu.
3. Select Counter as ON or OFF in the right menu.