Datasheet

are passed.

(3) In the right menu, select Coupling as AC. The direct current component of the signal

is blocked.

2. To invert a waveform

Waveform inverted: the displayed signal is turned 180 degrees against the phase of the

earth potential.

Taking the Channel 1 for example, the operation steps are shown as follows:

(1) Push the CH1 button to show the CH1 SETUP menu.

(2) In the right menu, select Inverted as ON, the waveform is inverted. Push again to

switch to OFF, the waveform goes back to its original one.

3. To adjust the probe attenuation

For correct measurements, the attenuation coefficient settings in the operating menu of

the Channel should always match what is on the probe (see "How to Set the Probe

Attenuation Coefficient" on P13). If the attenuation coefficient of the probe is 1:1, the

menu setting of the input channel should be set to1X.

Take the Channel 1 as an example, the attenuation coefficient of the probe is 10:1, the

operation steps are shown as follows:

(1) Push the CH1 button to show the CH1 SETUP menu.

(2) In the right menu, select Probe. In the left menu, turn the M knob to set it as 10X.

4. To measure current by probing the voltage drop across a resistor

Take the Channel 1 as an example, if you are measuring current by probing the voltage

drop across a 1Ω resistor, the operation steps are shown as follows:

(1) Push the CH1 button to show CH1 SETUP menu.

(2) In the right menu, set MeasCurr as Yes, the A/V radio menu will appear below.

Select it; turn the M knob to set the Amps/Volts ratio. Amps/Volts ratio = 1/Resistor

value. Here the A/V radio should be set to 1.

Use Mathematical Manipulation Function

The Mathematical Manipulation function is used to show the results of the addition,

multiplication, division and subtraction operations between two channels, or the FFT operation

for a channel. Press the Math button to display the menu on the right.

The Waveform Calculation

Press the Math button to display the menu on the right, select Type as Math.

Function Menu

Setting

Description

Type

Math

Display the Math menu

Factor1

CH1

CH2

Select the signal source of the factor1