Datasheet

11
How to Implement the General Inspection
After you get a new oscilloscope, it is recommended that you should make a check on the
instrument according to the following steps:
1. Check whether there is any damage caused by transportation.
If it is found that the packaging carton or the foamed plastic protection cushion has suffered
serious damage, do not throw it away first till the complete device and its accessories succeed
in the electrical and mechanical property tests.
2. Check the Accessories
The supplied accessories have been already described in the "Appendix A: Enclosure" of this
Manual. You can check whether there is any loss of accessories with reference to this
description. If it is found that there is any accessory lost or damaged, please get in touch with
the distributor of PEAKTECH responsible for this service or the PEAKTECH's local offices.
3. Check the Complete Instrument
If it is found that there is damage to the appearance of the instrument, or the instrument can
not work normally, or fails in the performance test, please get in touch with the PEAKTECH's
distributor responsible for this business or the PEAKTECH's local offices. If there is damage to
the instrument caused by the transportation, please keep the package. With the transportation
department or the PEAKTECH's distributor responsible for this business informed about it, a
repairing or replacement of the instrument will be arranged by the PEAKTECH.
How to Implement the Function Inspection
Make a fast function check to verify the normal operation of the instrument, according to the
following steps:
1. Connect the power cord to a power source. Press the button on the bottom left
of the instrument.
The instrument carries out all self-check items and shows the Boot Logo. Push the Utility
button, select Function in the right menu. Select Adjust in the left menu, select Default in the
right menu. The default attenuation coefficient set value of the probe in the menu is 10X.
2. Set the Switch in the Oscilloscope Probe as 10X and Connect the Oscilloscope with CH1
Channel.
Align the slot in the probe with the plug in the CH1 connector BNC, and then tighten the probe
with rotating it to the right side.
Connect the probe tip and the ground clamp to the connector of the probe compensator.