Datasheet

13. Current trigger type:

Rising edge triggering

Falling edge triggering

Video line synchronous triggering

Video field synchronous triggering

The reading shows the trigger level value of the corresponding channel.

14. It indicates the measured type and value of the corresponding channel. "T" means period,

"F" means frequency, "V" means the average value, "Vp" the peak-peak value, "Vr" the

root-mean-square value, "Ma" the maximum amplitude value, "Mi" the minimum

amplitude value, "Vt" the Voltage value of the waveform's flat top value, "Vb" the Voltage

value of the waveform's flat base, "Va" the amplitude value, "Os" the overshoot value,

"Ps" the Preshoot value, "RT" the rise time value, "FT" the fall time value, "PW" the

+width value, "NW" the -Width value, "+D" the +Duty value, "-D" the -Duty value, "PD" the

Delay A->B value, "ND" the Delay A->B value, "TR" the Cycle RMS, "CR" the

Cursor RMS, "WP" the Screen Duty, "RP" the Phase, "+PC" the +Pulse count, "-PC" the -

Pulse count, "+E" the Rise edge count, "-E" the Fall edge count, "AR" the Area, "CA" the

Cycle area.

15. The readings show the record length.

16. The frequency of the trigger signal.

17. The readings show current sample rate.

18. The readings indicate the corresponding Voltage Division and the Zero Point positions of

the channels. "BW" indicates bandwidth limit.

The icon shows the coupling mode of the channel.

"—" indicates direct current coupling

"～" indicates AC coupling

" " indicates GND coupling

19. The reading shows the setting of main time base.

20. It is cursor measure window, showing the absolute values and the readings of the

cursors.

21. The blue pointer shows the grounding datum point (zero point position) of the waveform

of the CH2 channel. If the pointer is not displayed, it means that this channel is not

opened.

22. The two blue dotted lines indicate the horizontal position of cursor measurement.

23. The yellow pointer indicates the grounding datum point (zero point position) of the

waveform of the CH1 channel. If the pointer is not displayed, it means that the channel is

not opened.