User Manual

21. Use LAN Port
Using the LAN port, the oscilloscope could be connected to a PC directly or through a router. Below
introduces these two kind of connection methods.
21.1. Connect directly via a LAN cable
1. View the network parameters of the computer
View the IP address of the computer to connect to. Assume the IP address is 192.168.1.71.
2. Set the network parameters of the oscilloscope
(1) Connect via USB and enter the menu: Use the supplied USB cable to connect the
oscilloscope with a PC through their USB ports. After connecting successfully, click
to show Function menu, choose "Utility", click "Network".
(2) Set IP and port of the oscilloscope: In Network menu, click "OK" to enter Machine Net
Setting.
Choose the oscilloscope to be connected from the list. If it's not in the list, click
"Refresh" to refresh the list.
Set IP, the first three bytes should be same as the IP address of the computer in step
1, the last byte should be different. Here, we set it to 192.168.1.72.
The range of the port value is 0 ~ 4000, here we set it to 3000.
(3) Click "Rework" to restart the oscilloscope.
3. Set the network parameters of the software
(1) Supply power: Disconnect the USB cable from the computer. Connect it with the AC-
adapter. Plug the adapter into an electrical outlet to power the oscilloscope.
(2) Connection: Plug in the LAN line to the LAN port of the oscilloscope; plug the other
end into the LAN interface of the computer.
(3) Set parameters in menu: Click to show Function menu, choose "Utility", click
"Network". Set IP and Port to the same value of the oscilloscope in step 2.
-96-