User Manual

Network
The oscilloscope could be connected to a PC via LAN port. For more details, see 21. Use LAN Port.
Tips Window
Choose a label among "Channel", "Capture&Period" or "Trigger" to view the guide for the new users.
Click anywhere in the help window to turn page.
If you do not want to display the guide automatically when running the software, check "Don't show
again".
About
Display Version, Serial Number and Company website.
SyncTrigger
Control the function of the port 5 in Ports of the Oscilloscope.
Trigger In: Input the trigger signal synchronously
Trigger Out: Output the trigger signal synchronously
Pass/Fail: Output high level when pass, output low level when fail.
20. How to Use Executive Buttons
Executive Buttons include Auto Set , Run/Stop / , Single Trigger . See 7, 8, 9 in 7.User
Interface.
AutoSet:
It's a very useful and quick way to apply a set of pre set functions to the incoming signal, and display
the best possible viewing waveform of the signal and also works out some measurements for user as
well.
The details of functions applied to the signal when using AutoSet are shown as the following table:
Function items
Setting
Acquisation Mode
Current
Vertical Coupling
DC
Vertical Scale
Adjust to the proper division
Horizontal Level
Middle
Horizontal Scale
Adjust to the proper division
Trigger Type
Current
Trigger Source
Show the minimum number of channels
Trigger Coupling
Current
Trigger Slope
Current
Trigger Level
Mid-point Setting
Trigger Mode
Edge
Display Format
YT
Run/Stop: Enable or disable sampling on input signals.
Single Trigger: You can set the trigger mode as single directly, so when trigger occurs,
acquire one waveform then stop.
-95-
Keyboard Shortcuts
Enter: Auto set
Space: Run/Stop