User Manual

Instruction of the status information
Auto Automatic trigger mode
Ready Ready for a trigger
Trig'd Has trigged
Scan Slow scan
Stop Data acquisition stopped
Error Error occurred
ReSyncing Synchronize with the oscilloscope again
AutoSet In process of auto setting
The statuses of not staying connected with the oscilloscope:
Offline No connection with the oscilloscope
USBFound Find available USB devices
USBDrvErr USB drivers installed error
MachineNotSupport Can not recognize the device
The statuses in the process of connecting with the oscilloscope:
Linking Being connecting with the oscilloscope
Connect connect successfully
Match Matching the model
Syncing Sync the settings
-72-
Keyboard Shortcuts
Space: Run/Stop
Enter: Auto set
Q: The voltage division of Channel 1 decreases one
level
A: The voltage division of Channel1increases one
level
W: The voltage division of Channel2decreases one
level
S: The voltage division of Channel2increases one level
←: Time base decreases one level
→: Time base increases one level
F1: Open this help document