User Manual

45. Technical Specifications
Unless otherwise specified, the technical specifications applied are applicable to the probe with the
attenuation switch setting 10X and the PeakTech
®
digital oscilloscopes. Only if the oscilloscope fulfill the
following two conditions at first, can these specification standards be reached.
* This instrument should run for more than 30 minutes continuously under the specified operating
temperature.
* If the change range of the operating temperature is up to or exceeds 5°C, open the system function
menu and execute the “Auto-calibration” procedure.
All specification standards can be fulfilled, except one(s) marked with the word “Typical”.
Digital Storage Oscilloscope
Performance Characteristics
Instruction
Bandwidth
100 MHz (P 1190)
200 MHz (P 1230)
Channel
2 + 1 (External)
Acquisition
Mode
Normal, Peak detect, Averaging
Sample rate (real time)
P 1190:
Dual CH: 500MSa/s
Single CH: 1 GSa/s
P 1230:
Dual CH: 1 GSa/s
Single CH: 2 GSa/s
Input
Input coupling
DC, AC, Ground
Input impedance
1 MΩ ± 2 %，in parallel with 15 pF ± 5 pF
Probe attenuation factor
1X,10X, 100X, 1000X
Max. input voltage
400 V (PK-PK) (DC + AC PK-PK)
Bandwidth limit
20 MHz, 100 MHz
Channel isolation
50 Hz: 100 : 1
10 MHz: 40 : 1
Time delay between
channel (typical)
150 ps
-226-