User Manual

Video Line Trigger
For the trigger in the video line, please operate according to the following steps:
1. Push down the TRIG MENU button to display the trigger menu.
2. Press the F1 menu selection button and choose Single for Type.
3. Press the F2 menu selection button and choose CH1 for Source.
4. Press the F3 menu selection button and choose Video for mode.
5. Press the F4 menu selection button and choose Line for Sync.
6. Adjust the VOLTS/DIV, VERTICAL POSITION and SEC/DIV knobs to obtain the proper wave form
display (see Fig. 112).
Fig. 112 Wave Form Obtained from the Video Line Trigger
-224-