User Manual

For example:
To set “WAVE 0” in memory ID to save current waveform and “setting 0” to save current setting.
Follow up below steps:
1. Press “C(SAVE/REL)” after data acquisition finished and storage menu appears
2. Press “F1” till storage display as “Waveform”
3. Press “F2” till memory ID. Display as “Waveform 0”
4. Press “F3” to save current display waveform. Info window will show “Waveform saving” then show as
“Waveform saved successfully” when storage finished.
5. Press “F1” till memory SEL as “Setups”
6. Press “F2” till memory ID. display as “Setups 0”
7. Press “F3” to save current various settings. Info window show “Setting saved successfully”.
8. Press “F4” to recall the memory waveform or settings (refer to Fig. 96)
Fig. 97 Waveform saving
-209-