User Manual

For example:
To set BUS0 as BUS to include CH00, CH01, CH02, CH03 and code as hex system. Follow up as below:
1. Press “0(BUS)” to and BUS menu appears
2. Press “F1” till BUS display as “BUS0”
3. Press “F2” or turn “CH1 Volts/div” knob till channel display as “CH00”
4. Press “F3” and set CH00 as “Include”. Then Channel CH00 refer to display of “1”
5. Repeat the operation of steps 2. 3 and set CH01, CH02, CH03 as “Include” and other channel as
“exclude”. Then “CH SEL” display as “XXXXXXXXXXXX1111”. BUS setting finished.
6. Press “F4” and set code type as “HEX”
BUS setting is finished (refer to Fig. 94).
Fig. 94 Bus setting
-206-