User Manual

For example:
Display channel as CH00~CH03 and BUS as BUS0, other channels and BUS all off. Follow up below steps:
1. Press “A(DISPLAY)” and display menu appears
2. Press “F1” till signal source display as “BUS”
3. Press “F2” till BUS No. display as “BUS0”
4. Press “F3” to choose signal display as “ON”.
5. Press “F2” till BUS No. display as “BUS1”.
6. Press “F3” to choose signal display as “OFF”. Repeat the operation of steps 5.6 and set BUS2, BUS3 as
“OFF”.
7. Press “F1” till signal source display as “Channel”
8. Press “F2” or turn “CH1 Volts/div” knob till channel display as “CH00”.
9. Press “F3” to choose signal source as “ON”.
10. Repeat operation of steps 8.9 and set CH01, CH02, CH03 as “ON”.
11. Press “F2” or turn “CH1 Volts/Div” knob till channel display as CH04.
12. Press “F3” to choose signal display as “OFF”.
13. Repeat operation of steps 8.9 and set CH05~CH0F all as “OFF”.
Channel display setting finished (refer to Fig. 92)
Fig. 92 Display setting
-204-