User Manual

To observe the 16 channel data need to know how data changed before and after when "BIT0-BIT3" STATE is
“0111”.
1. Press “Trigger menu” and menu appears.
2. Press “F1” till trigger mode display as “Pattern”
3. Press “F2” or turn “CH1 Volts/div” knob till “CH SEL” display as “CH00”
4. Press “F3” till F3 window display as “CH00/High” and “CH00” in F2 window display as “1”.
5. Repeat operation of step D and set CH01, CH02 to “High” and CH03 as “Low”,CH04~CH0F set as
“Don’t care”.
Pattern trigger setting finished (refer to Fig. 82) and ready for data acquisition.
Fig. 82 Pattern trigger
-195-