User Manual

figure 45: Use the Cursor for a Voltage Measurement
To use the cursor for a time measurement, do the following:
1. Press the MENU key and the function menus are displayed at the right of the screen.
2. Press the MENU ▲ or MENU ▼ key to select CURS MEAS key. Four key labels selectable are shown at
the bottom of the screen.
3. Press the F1 key to the measurement type Time. Two vertical dashed lines T1 and T2 appear on the
screen.
4. Press and hold the OSC OPTION key till the ▲/▼ CURSOR 1 appears on the screen. Then, adjust the
OSC ▲ or OSC ▼ and you can observe the dashed line moving left and right. At the same time, the time
value of T1 relative to the screen middle point position will be displayed on the Curs1 item at the bottom of
the screen.
5. Keep pressing on the OSC OPTION key till the ▲/▼ CURSOR 2 is displayed on the screen. Then,
adjust the OSC ▲ or OSC ▼ and you can find that the dashed line T2 is moving right and left while the
time value of T1 relative to the screen middle point position appears on the Curs2 item at the bottom of
the screen. You can also observe the absolute time values of T1 and T2 on the Delta item at the bottom of
the screen..
Now, you can see a screen that looks like the following figure 46.
figure 46: Use the Cursor for a Time Measurement
-96-