User Manual

6.6 Taking a Relative Measurement
A currently measured result relative to the defined reference value is displayed in a relative measurement.
The following example shows how to take a relative measurement. At first, it is required to acquire a reference
value.
1. Press R key and R is displayed on the top side of the screen.
2. Press the AUTO SET key till C appears at the top of the screen.
3. Plug capacitance extended module in capacitance measure jack.
4. When the reading leveling off, press F2 key and
△
△△
△ is displayed on the top side of the screen. The saved
reference value is displayed below △
△△
△.
5. Plug capacitance, the displayed major reading on the screen is actual the capacitance value.
Look at the display, you can see a screen that looks like the following figure 29.
figure 29: Relative Measurement
6.7 Selecting Automatic/ManualRange Adjustment
The defaulted range mode of the instrument is automatic range. To switch to the manual range, perform the
following steps:
1. Press F1 key and MANUAL is displayed on the top left side of the screen to enter the manual range
mode.
2. Under the manual range mode, the measuring range is increased by a stage when pressing F1 key each
time, and when reaching the highest stage, it jumps to the lowest stage by pressing F1 key once again.
To multiply the reading of dial pointer by multiplying power and the unit of main reading on the screen will
get the measurement result.
3. Press F3 key and AUTO is displayed on the top left side of the screen to switch back to the automatic
range mode.
Look at the display, you can see a screen that looks like the following figure 30.
-80-