User Manual

5.6 Resetting the Oscilloscope
If you want to reset the Oscilloscope to the factory settings, do the following:
1. Press MENU key and the function menu appears on the right side of the screen
2. Press the MENU or MENU key to select FUNCTION setting and three options are
visible at the bottom of the screen.
3. Press F1 key to select the factory settings. The oscilloscope is set to be the factory
settings.
See the following figure 9:
figure 9: Reset the Oscilloscope
5.7 Input Connections
See figure 2.
Look at the bottom and the right of the Oscilloscope. The Oscilloscope has six signal inputs: one safety BNC
jack inputs for scope measurements, three safety 4-mm banana jack inputs for Multimeter R, V and A
measurements, and two quadratic jack inputs for Multimeter capacitance measurements.
Isolated input allows independent floating measurements between Multimeters and Scopes.
5.8 Displaying an Unknown Signal with Auto Set
The Auto-Set feature lets the Oscilloscope display and measure unknown signals automatically. This function
optimizes the position, range, time base, triggering and assures a stable display of virtually any waveform.
This feature is especially useful for quickly checking several signals.
To enable the Auto-Set feature, do the following:
1. Connect the test probe to the tested signals.
-64-