User Manual

1. Press F1 key and MANUAL is displayed on the top left side of the screen to enter the manual range
mode.
2. Under the manual range mode, the measuring range is increased by a stage when pressing F1 key each
time, and when reaching the highest stage, it jumps to the lowest stage by pressing F1 key once again.
To multiply the reading of dial pointer by multiplying power and the unit of main reading on the screen will
get the measurement result.
3. Press F3 key and AUTO is displayed on the top left side of the screen to switch back to the automatic
range mode.
Look at the display; you can see a screen that looks like the following Figure .
Figure 33: Automatic/Manual Range Adjustment
ATTENTION:
Capacitance measurement without manual range mode.
7. Advanced Function of Oscilloscope
This chapter will detail the oscilloscope function of the test tool.
7.1. Setting the Vertical CH1 and CH2
Each channel has its own independent vertical menu and each item can be set respectively based on the
specific channel.
To make vertical CH1 and CH2 settings, do the following:
1. Press the MENU key and the function menu appears at the right of the screen.
2. Press the MENU ▲ or MENU ▼ key to jump to CH1 Setting and 4 options appears at the bottom of the
screen.
3. Select key from F1 to F4 to make different settings.
Now, you can find a screen that looks like the following Figure .
-87-