User Manual

Look at the display; you can see a screen that looks like the following Figure.
Figure 31: Freezing the Readings
6.3. Taking a Relative Measurement
A currently measured result relative to the defined reference value is displayed in a relative measurement.
The following example shows how to take a relative measurement. At first, it is required to acquire a reference
value.
1. Press R key and R is displayed on the top side of the screen.
2. Press the SET key till C appears at the top of the screen.
3. Plug capacitance extended module in capacitance measure jack.
4. When the reading leveling off, press F2 key and ▲ is displayed on the top side of the screen. The saved
reference value is displayed below ▲.
5. Plug capacitance, the displayed major reading on the screen is actual the capacitance value.
Look at the display; you can see a screen that looks like the following Figure.
Figure 32: Relative Measurement
6.4. Selecting Automatic/ManualRange Adjustment
The defaulted range mode of the instrument is automatic range. To switch to the manual range, perform the
following steps:
-86-