User Manual

6.1.2. Measuring Diode
To make a measurement on the diode, do the following:
1. Press the R key and R appears at the top of the screen.
2. Press SET key till the following is displayed on the screen .
3. Insert the black lead into the COM banana jack input and the red lead into the V/ banana jack input.
4. Connect the red and black leads to the resistor and the diode resistor readings are displayed on the
screen in V.
Now, you can see a screen that looks like the following Figure.
Figure 22: Diode Measurement
6.1.3. Continuity Test
To perform the continuity-test, do the following:
1. Press the R key and R appears on the top of the screen.
2. Press the SET key till the following is shown on the screen.
3. Insert the black lead into the COM banana jack input and the red lead into the V/Ω banana jack input.
4. Connect the red and black leads to the test point. If the resistance value of the tested point is less than
50, you will hear beep sound from the test tool.
Now, you can see a screen that looks like the following Figure.
Figure 23: Continuity-Test
-81-