User Manual

The screen that looks like the following Figure will be displayed.
Figure 60: Window Setting
Figure 61: Window Extension
7.16. Data Transmission
For the operation of data transmission, please execute the following steps:
1. Press MENU key, display the function menu on the right side of the screen.
2. Press MENU ▲ or MENU ▼ key to select display setting mode, display four options at the bottom.
3. Press F4 key; select the Bitmap or Vectors for data transmission.
4. Use a data line to connect the oscilloscope and the PC.
5. Open the Oscilloscope software that had been installed completely.
6. Setting the parameter under the use’s manual, and then starts data transmission.
8. Appendix
8.1. Installation of the software
The installation of the software is needed to operate the PeakTech
®
1195/1205 oscilloscope in connection
with the PC.
To install the Interface-Program and USB-driver, please follow below procedure:
-115-