User Manual

Now, you can see a screen that looks like the following Figure:
Figure 50: Use the Cursor for a Time Measurement
7.11. Autoscale
The function is applied to follow-up signals automatically even if the signals change at any time. Autoscale
enables the instrument to set up trigger mode, voltage division and time scale automatically according to the
type, amplitude and frequency of the signals.
The menu is as follows:
Function menu
Settings
Description
Autoscale
OFF
ON
Turn off Autoscale
Turn on Autoscale
Mode
Vertical
Horizontal
HORI—VERT
Follow-up and adjust vertical scale without changing horizontal
setting.
Follow-up and adjust horizontal scale without changing vertical
setting.
Follow-up and adjust the vertical and horizontal settings.
Only show one or two periods.
Show Multi-period waveforms.
If you want to measure voltage of Channel 1, you can do as the follows:
1. Press MENU, the function menu will appear on the right of the screen.
2. Press MENU ▲ or MENU ▼ and choose Autoscale, three options will show at the bottom of the screen.
3. Press F1 and choose ON.
4. Press AUTOSET.
Pressing AUTOSET to enter into Autoscale function and flicker on the top left corner. (flicker every 0.5
second).
If the Autoscale function is off, pressing AUTOSET is just to enter into AUTOSCALE function.
5. Press F2 and choose Hori-Vert.
6. Press F3 and displays on the screen as following Figure:
-105-